<< Click to Display Table of Contents >> Navigation:  Chapter 4 Models > Editing a Model > Editing a Primary Landfill Model > General Data

To select the layers in the model and edit the general data click on the General tab on the left side of the model form.

 

 

The following can be specified on this tab:

 

General Information

 

Model Title: This is the title of the model is used to describe the model, and may be up to 255 characters long.

 

Units: This is used to select the units to use when creating the model.

 

Geomembrane: Check this box to include a primary geomembrane in the model. If this box is not checked the Geomembranes tab will not be present.

 

Clay Liner: Check this box to include a primary clay liner in the model. If this box is not checked the Clay Liners tab will not be present.

 

Aquitard: Check this box to include an aquitard in the model. If this box is not checked the Aquitard tab will not be present.

 

Aquifer: Check this box to include an aquifer in the model. If this box is not checked the Aquifer tab will not be present.

 

 

Laplace Transform Parameters and Run Parameters

 

The information specified for the Laplace Transform Parameters and Run Parameters is the same as described in the General Data section for a Normal Model.