Sliders

<< Click to Display Table of Contents >>

Navigation:  Chapter 12 3D Display > Editing a 3D View > Adjusting the Display >

Sliders

Previous pageReturn to chapter overviewNext page

The sliders in the sidebar can be used to adjust the following:

 

clip0118

This slider bar can be used to zoom the display in and out. Slide the control to the left to zoom out and to the right to zoom in.

 

clip0135

This slider can be used  to adjust the grid elevation. To raise the grid move the slider to the right and to lower the grid move the slider to the left.

 

clip0129

 

The diameter of the hole size of the boring/wells on the display can be adjusted using the Hole Size slider on the sidebar. Slide the bar to the right to increase the hole size and to the left to decrease the hole size.

 

clip0127

After the overlay is displayed, it's opacity can be adjusted using the Overlay Opacity slider on the sidebar. Slide the bar to the right to make the overlay more opaque and to the left to make the overlay more transparent.

 

clip0128

The elevation of the overlay can be adjusted using the Overlay Elevation slider on the sidebar. Slide the bar to the right to raise the overlay and to the left to lower the overlay.

 

clip0132

After the map is displayed, it's opacity can be adjusted using the Map Opacity slider on the sidebar. Slide the bar to the right to make the map more opaque and to the left to make the map more transparent.

 

clip0187

The elevation of the map can be adjusted using the Map Elevation slider on the sidebar. Slide the bar to the right to raise the map and to the left to lower the map.

 

clip0134

The amount of material a cut-out removes can be controlled using the Cutout Size slider on the sidebar.