Toolbar

<< Click to Display Table of Contents >>

Navigation:  Chapter 12 3D Display > Editing a 3D View > Adjusting the Display >

Toolbar

Previous pageReturn to chapter overviewNext page

clip0183

 

 

The toolbar buttons can be used to perform the following functions. In addition, some of these functions are available on the Edit menu as stated.

 

clip0186 This button is used to show or hide the sidebar.

 

clip0119 There are several preset views that can be used to position the display quickly. To access these presets either use the Preset View button on the toolbar or select Edit > View Presets. The following preset views can be selected North, South, East, West, and Top down. In addition, the pitch and yaw can be specified using these menus. The Specify Angles below will be displayed where you can specify the pitch and yaw in degrees.

 

                clip0121

 

clip0114 Tilt the view left or Edit > Tilt > Left.

 

clip0115 Tilt the view right or Edit > Tilt > Right.

 

clip0116 Tilt the view forward or Edit > Tilt > Forward.

 

clip0117 Tilt the view backward or Edit > Tilt > Backward.

 

clip0185 This button is used to reset the view back to it's original state.Or select Edit > Reset View.

 

clip0184 Portions of a solid can be cut-out to show details inside the solid by selecting the solid on the sidebar and then clicking on the Cutout button on the toolbar. Or select Edit > Add Cutout.