<< Click to Display Table of Contents >> Navigation:  Chapter 7 Stations and Sampling > Samples > Editing a Sample > Media Data Tabs > Groundwater Data Tab

The Groundwater Data tab is used to specify the information that pertains to groundwater media.  These groundwater samples can later be linked to a well log in the WinLoG module using the associated Well specified on the Information tab.

 

 

The following can be specified on this tab:

 

Water Depth: This is the depth to the water and depth units.

 

Depth Collected. This is the depth that the sample was collected.

 

Measurement Method: This is the method that was used to measure depths.

 

Monitoring Round: This is used to specify the monitoring round.

 

Volume Collected: This is used to specify the volume collected and the volume units.

 

Color: This is used to select the color from a list of Colors.

 

Odour: This is used to select the odour from a list of Odours.

 

Shine: This is used to specify if there is a shine on the water.

 

LNAPL Present: This is used to specify if an LNAPL is present.

 

LNAPL Depth: If an LNAPL is present, this is used to specify the depth of the LNAPL.