Grout Information Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 9 Geotechnical Data Management > Geotechnical Tests > Entering Test Data > Concrete Tests > Grout Compressive Strength > Data Entry >

Grout Information Tab

Previous pageReturn to chapter overviewNext page

This tab is used to specify the information for the grout specimens.

 

clip40254

 

The following can be entered and displayed on this tab:

 

Information

 

Specimen Type: This is used to select the type of specimen. It can either be grout cube, grout cylinder, or masonry cube.

 

Batch Date: This is used to specify the date and time the grout was batched.

 

Pour Date: This is used to specify the date and time the grout was poured.

 

Supplier: This is used to select the grout supplier from a predefined list of suppliers. To get detailed information about the supplier click on the button on the right.

 

Truck Number: This is used to specify the truck number delivering the grout.

 

Ticket Number: This is used to specify the ticket number for the grout.

 

Curing Method: This is used to select the curing method from a predefined list of curing methods.

 

Water Used: This is used to specify the water used to the nearest 0.1%.

 

Flow: This is used to specify the flow to the nearest 1%.

 

Test Location: This is used to select the test location, either laboratory or field.

 

Initial Temperature: This is used to specify the initial temperature.

 

Ambient Temperature: This is used to specify the ambient temperature.

 

Site Conditions: This is used to describe the site conditions.

 

Options

 

Specify Times: Check this box to specify the times of the compressive strength measurements.

 

Auto Increment Specimen Number: Check this box to automatically increment the specimen number for compressive strength measurements.

 

Determine Density: Check this box to calculate the density for each compressive strength measurement.

 

Calculate Volume: If the density is being determined, check this box to calculate the volume based on the specify dimensions otherwise the volume can be specified.

 

Units

 

Temperature Units: This is used to select the units for temperature.

 

Length Units: This is used to select the units for length.

 

Load Units: This is used to select the units for load.

 

Strength Units: This is used to select the units for strength.

 

Mass Units: This is used to select the units for mass.

 

Volume Units: If the density is being determined, this is used to select the units for volume.

 

Density Units: If the density is being determined, this is used to select the units for density.