<< Click to Display Table of Contents >> Navigation:  Chapter 5  Boring/Wells > Templates > Editing a Template > Draw Objects > Tables > Adding a Table

 

To add a table to a template click on the Table button on the toolbar. Next using the left mouse button click on the location of the upper left corner of the table. Then while holding the left mouse button down drag the mouse to the location of the lower right corner. Then release the mouse button. While the mouse button is held down a marquee box will be drawn to indicate the location of the table. After the button has been released, the Table form described in the next section will be displayed. This form can also be used to add a table using the Add button at the bottom of the form.