<< Click to Display Table of Contents >> Navigation:  Chapter 3 Projects > Project Management > Georeferencing a Project > Georeferencing Manually

After the project has been selected. the Georeference Project form below will be displayed.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following information can be specified on this form:

 

Project Number: This is the project number.

 

Project Name: This is the project name.

 

Project Map Boundaries: These are the project's boundaries on the basemap in map and local units. These boundaries will change as the corner identified on the map is changed.

 

Corner Identified on Map: This is the corner of the project that was used to identify the location on the basemap.

 

Map X: This is the X location, normally longitude, for the corner on the basemap.

 

Map Y: This is the Y location, normally latitude, for the corner on the basemap.

 

Local Project Units: This is the local units for the project. If the project has already been georeferenced and is only being re-positioned this will not appear.