<< Click to Display Table of Contents >> Navigation:  Chapter 5  Boring/Wells > Templates > Opening a Template

No project can be open when opening a template. Existing templates can be opened for editing by selecting File > Open > Boring/Well Template or clicking the Open button on the Main Toolbar and selecting Boring/Well Template. The Select Template form will be displayed.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

This form displays lists of the most recently used templates and all templates on the left side. The right side will display the details of the highlight template, some of the details of the most recent template may not be displayed. At the top of the list of all templates the industry type and page type for the template can be selected, these can be used to refine the list of templates. To select a template, highlight and press the Ok button.

 

At the bottom of the form the Change Industry button can be used to change the industry for a template. After a template is selected, when the button is pressed the new industry for the template can be selected for the template from the drop down list that will be shown next to the button.