Author: GAEA Technologies
Posts
-
Can a company logo be included in a WinLoG template?
Yes, company logos that are stored as bitmaps can be placed anywhere on a template. To add a logo to a template, follow the steps below:
-
Can an aboveground cover or well “stick-up” be shown on a borehole log in WinLoG?
An aboveground cover can be shown by specifying a negative (above ground surface) start depth for the log. To draw a portion of the piezometer or well aboveground set the start depth of the log to a negative number (e.g. -2 feet). Then start the well interval for the cap with a negative top depth…
-
How do I transfer the software from one computer to another?
Transferring your software license to a new computer doesn’t have to be a hassle. The key is to plan ahead and ensure that your new system is set up before you make the switch. Start by making sure your annual maintenance is up to date. Transferring the License To transfer the license you will need…
-
How do I Register a License
Most of our software can be licensed on individual computers, a network, or a combination of both. The licenses can either be perpetual or subscription based. When licensed on a network the licensing is based on concurrent usage, where the number of concurrent users must be less than or equal to the maximum number of…
-
Why is my WinLoG header data not displaying on the log?
The titles in the template and data types for the log must match exactly (including spaces and capitals). This is normally no problem since the data types for the log are created using the template titles when the log is created. However, if the template titles are edited after the logs are created this can…
-
How do I add strata to a cross-section in WinFence?
You can add the strata using the steps below.
-
How do I snap strata in WinFence?
WinFence uses a unique snapping approach that can be used to quickly add layer, alteration zone, intrusion, and lense boundaries. The number of boundaries a strata has depends on the type of strata. Layers have a top and bottom boundary. Faults, lenses, alteration zones and intrusions have only one boundary. These boundaries can be defined…
-
How do I create a cross-section in WinFence?
To create a new cross-section click on the New button on the Cross-Section toolbar. Then click the “Pencil Tool” to draw the path of the cross-section. To add boreholes to a section click on or very near the borehole. This will add the borehole to the new cross section. Then double click to end the…
-
Why do some of the WinLoG headers in my template not appear when entering boring data?
There are two types of header data, text data and memos. Text data is limited to 255 characters and there is no limit to the length of memo data. When the headers are specified in the template, you can specify the header as either text data or a memo. If a width or height is…

